Table of Contents
Advertisement
Procedure
1.
Remove the front bezel on page 39.
2.
Power down the server on page 38.
3.
Remove all power:
a. Disconnect each power cord from the power source.
b. Disconnect each power cord from the server.
4.
Disconnect all peripheral cables from the server.
5.
Do one of the following:
•
Server in tower mode: Position the tower server for hardware configuration on page 41.
•
Server in rack mode: Extend the server from the rack on page 43.
6.
Remove the access panel on page 48.
7.
Remove the air baffle on page 50.
8.
Remove the PCI blank retainer on page 56.
9.
Remove the PCI slot blank on page 57.
10. If the M.2 SSD enablement board option does not include a screw for installation, remove one of the
preinstalled PCI board screw.
11. If the SSD is not preinstalled on the M.2 SSD enablement board, do the following:
If only one SSD is being installed, install the SSD in port 1.
a. Insert the SSD module into the SSD slot at a 45° angle.
b. Carefully press the SSD down to the horizontal position.
c. Install the M.2 SSD mounting screw.
d. If you are installing a second SSD, repeat steps a–c.
12. Install the M.2 SSD enablement board.
Hardware options installation
131
Advertisement
Table of Contents
