Table of Contents
Advertisement
The embedded HPE Smart Array S100i SR Gen10 Controller supports SATA drive installation. For SAS
support, connect the drive to a Smart Array Gen10 type-a or type-p controller option.
Installing an LFF non-hot-plug drive
Prerequisites
Before you perform this procedure:
•
Make sure that the LFF non-hot-plug drive cage is available.
•
Make sure that you have the following items available:
◦
LFF non-hot-plug drive option
◦
T-15 Torx screwdriver
Procedure
1.
Remove the front bezel on page 39.
2.
Power down the server on page 38.
3.
Remove all power:
a. Disconnect each power cord from the power source.
b. Disconnect each power cord from the server.
4.
Disconnect all peripheral cables from the server.
5.
Do one of the following:
•
Server in tower mode: Position the tower server for hardware configuration on page 41.
•
Server in rack mode: Extend the server from the rack on page 43.
6.
Remove the access panel on page 48.
7.
Remove the air baffle on page 50.
8.
If installed, remove the fan cage.
9.
If the LFF non-hot-plug drive cage is already installed, do the following:
a. If there are drives already installed in the cage, disconnect the SATA-power split cable from the
drives.
b. Remove the drive cage.
10. Remove the spare screws from the drive cage.
11. Install the drive.
Installing an LFF non-hot-plug drive
65
Advertisement
Table of Contents
