Table of Contents
Advertisement
•
Make sure that the LFF hot-plug drive cage is installed.
•
Make sure that the LFF hot-plug drive option is available.
Procedure
1. Open the front bezel on page 39.
2. Remove the drive blank.
3. Prepare the drive.
4. Install the drive.
5. Determine the status of the drive from the drive LED definitions.
6. Close the front bezel.
The installation is complete.
To configure arrays, see the HPE Smart Array SR Gen10 Configuration Guide at the Hewlett Packard
Enterprise website.
Hardware options installation
67
Advertisement
Table of Contents
