Extend the server from the rack
Procedure
1. If the rear panel cables are not secured by a cable management arm, do the following:
a. Open the front bezel on page 39.
b. Power down the server on page 38
c. Disconnect all peripheral cables from the server.
d. Disconnect each power cord from the server.
e. If front panel access is no longer needed, close the bezel.
WARNING:
To reduce the risk of personal injury or equipment damage, be sure that the rack is adequately stabilized
before extending a component from the rack.
2. Slide the server tray out of the rack:
a. Loosen the server tray thumbscrews.
b. Grasp the tray notch to slide the server out of the rack.
Extend the server from the rack
43