Table of Contents
Advertisement
•
Make sure that the fan cage option is installed.
•
Make sure that you have a T-15 Torx screwdriver available.
Procedure
1. Open the front bezel on page 39.
2. Power down the server on page 38.
3. Close the front bezel.
4. Remove all power:
a. Disconnect each power cord from the power source.
b. Disconnect each power cord from the server.
5. Disconnect all peripherals cables from the server.
6. If installed, unlock and remove the security padlock and/or the Kensington security lock.
For more information, see the lock documentation.
7. Position the tower server for hardware configuration on page 41.
8. Remove the chassis feet.
a. Loosen the screws on the chassis.
b. Detach the chassis feet.
Install the rack rails and server tray
These rack rails can be installed in both round- or square-hole racks.
Prerequisites
Before you perform this procedure, make sure that you have the following items available:
•
Left and right rack rail assemblies – These rails occupy 1U position on the rack.
•
Server tray
•
T-15 Torx screwdriver
Procedure
1. Disassemble the rail assemblies:
80
Install the rack rails and server tray
Advertisement
Table of Contents
