Table of Contents
Advertisement
WARNING:
To reduce the risk of personal injury, electric shock, or damage to the equipment, remove power from
the server by removing the power cord. The front panel Power On/Standby button does not shut off
system power. Portions of the power supply and some internal circuitry remain active until AC power
is removed.
WARNING:
To reduce the risk of personal injury from hot surfaces, allow the drives and the internal system
components to cool before touching them.
2. Update the system ROM.
Locate and download the latest ROM version from the Hewlett Packard Enterprise Support Center
website. Follow the instructions on the website to update the system ROM.
3. Power down the server (Power down the server on page 38).
4. Remove all power:
a. Disconnect each power cord from the power source.
b. Disconnect each power cord from the server.
5. Do one of the following:
•
Server in tower mode: Position the tower server for hardware configuration on page 41.
•
Server in rack mode: Extend the server from the rack on page 43.
6. Remove the access panel on page 48.
7. Remove the air baffle on page 50.
8. Remove any options installed in the PCIe3 expansion slots 1–4.
9. Proceed to Installing the TPM board and cover on page 140.
Installing the TPM board and cover
Procedure
1. Observe the following alerts:
CAUTION:
If the TPM is removed from the original server and powered up on a different server, data stored in
the TPM including keys will be erased.
CAUTION:
The TPM is keyed to install only in the orientation shown. Any attempt to install the TPM in a different
orientation might result in damage to the TPM or system board.
2. Align the TPM board with the key on the connector, and then install the TPM board. To seat the board,
press the TPM board firmly into the connector. To locate the TPM connector on the system board, see the
server label on the access panel.
140
Hardware options installation
Advertisement
Table of Contents
