Table of Contents
Advertisement
5.
Verify the operation of the rack rails and the CMA:
Two people might be needed for this procedure: one to slide the server tray in and out of the rack, and
the other to observe the cables and CMA.
a. Fully extend the server tray out of the rack.
b. Check that there is enough slack in the cables and cords to allow for full extension of the CMA without
any cable binding or crimping.
c. Slide the server tray in and out of the rack to make sure that the cables and the CMA are working
properly.
6.
Press and hold the blue rail-release tabs, and then slide the tray back into the rack.
7.
Tighten the server tray thumbscrews.
Hardware options installation
87
Advertisement
Table of Contents
