11. Install the GPU in the riser cage, and then connect the cable to the GPU.
12. If installing a GPU requiring greater than 75 W, connect the power cable to the primary riser power
connector.
13. Install the access panel (Installing the access panel on page 25).
14. Install the server in the rack.
15. Connect each power cord to the server.
16. Connect each power cord to the power source.
17. Power up the server (Powering up the server on page 24).
Controller options
Installing an HPE Smart Array P408i-a Controller option
Prerequisites
Before installing this option, be sure that you have the following:
82
Controller options