Table of Contents
Advertisement
•
The controller data sheet on the Hewlett Packard Enterprise website (https://www.hpe.com/h20195/V2/
Getdocument.aspx?docname=a00017196enw)
•
The controller QuickSpecs on the Hewlett Packard Enterprise website (http://www.hpe.com/info/qs).
Installing an HPE Smart Array P408i-a SR Gen10 Controller option
Prerequisites
Before installing this option, be sure that you have the following:
•
The components included with the hardware option kit.
•
T-15 Torx screwdriver.
Procedure
1.
Observe the following alerts:
WARNING: To reduce the risk of personal injury from hot surfaces, allow the drives and the internal system
components to cool before touching them.
CAUTION: To prevent damage to electrical components, properly ground the server before beginning any
installation procedure. Improper grounding can cause electrostatic discharge.
2.
Back up all server data.
3.
Power down the server on page 31.
4.
Remove all power:
a. Disconnect each power cord from the power source.
b. Disconnect each power cord from the server.
5.
Do one of the following:
a. Extend the server from the rack on page 31.
b. Remove the server from the rack on page 32.
6.
Remove the access panel on page 32.
7.
Install the controller.
Hardware options installation
101
Advertisement
Table of Contents
