Enabling Ssh Server; Configuring The User Interfaces For Ssh Clients - H3C S7500E Series Operation Manual

Operation Manual – SSH
H3C S7500E Series Ethernet Switches

1.2.2 Enabling SSH Server

Follow these steps to enable SSH server:
Enter system view
Enable the SSH server
function

1.2.3 Configuring the User Interfaces for SSH Clients

An SSH client accesses the device through a VTY user interface. Therefore, you need
to configure the user interfaces for SSH clients to allow SSH login. Note that the
configuration takes effect at the next login.
Follow these steps to configure the protocols for the current user interface to support:
Enter system view
Enter user interface view
of one or more user
interfaces
Set the login
authentication method to
scheme
Specify the protocols for
the user interfaces to
support
Caution:
For detailed information about the authentication-mode and protocol inbound
commands, refer to Login Commands.
If you configure a user interface to support SSH, be sure to configure the
corresponding authentication method with the authentication-mode scheme
command.
For a user interface configured to support SSH, you cannot configure the
authentication-mode password command and the authentication-mode none
command.
To do...
system-view
ssh server enable
To do...
system-view
user-interface vty
number [ ending-number ]
authentication-mode
scheme
[ command-authorizatio
n ]
protocol inbound { all |
ssh | telnet }
Use the command...
Use the command...
1-6
Chapter 1 SSH Configuration
Remarks
—
Required
Disabled by default
Remarks
—
Required
Required
By default, the
authentication mode is
password.
Optional
All protocols are
supported by default.