Display Poe Pse Interface Power - HPE FlexNetwork 7500 Series Network Management And Monitoring Command Reference

Field
Detection Status
On State Ports
Used
Remaining

display poe pse interface power

Use display poe pse interface power to display power information for PIs on a PSE.
Syntax
display poe pse pse-id interface power
Views
Any view
Predefined user roles
network-admin
network-operator
mdc-admin
mdc-operator
Parameters
pse pse-id: Specifies a PSE by its ID.
Usage guidelines
To display PSE ID and slot mappings, use the display poe device command.
This command is only available for the default MDC. For more information about MDCs, see Virtual
Technologies Configuration Guide.
Examples
# Display power information for PIs on PSE 7.
<Sysname> display poe pse 7 interface power
Interface
GE1/0/25
GE1/0/26
GE1/0/27
GE1/0/28
GE1/0/29
Current Peak
(W) (W)
4.4 4.5
4.4 4.5
15.0 15.3
0.0 0.0
0.0 0.0
Description
hyphen (-).
Power detection status of a PI:
•
Disabled—PoE function is disabled.
•
Searching—The PI is searching for the PD.
•
Delivering Power—The PI is supplying power to the PD.
•
Fault—A fault occurred during the test.
•
Test—The PI is undergoing a test.
•
Other Fault—A fault has caused the PSE to enter the idle status.
•
PD Disconnected—The PD is disconnected.
Number of PIs that are supplying power.
Power consumed by PIs on the PSE.
Remaining power on the PSE.
Max PD Description
(W)
4.6 IP Phone on Room 309 for Peter Smith
15.4 IP Phone on Room 409 for Peter Pan
15.4 Access Point on Room 509 for Peter
5.0 IP Phone on Room 609 for Peter John
4.0 IP Phone on Room 709 for Jack
138