Poe Mode - HPE FlexNetwork 7500 Series Network Management And Monitoring Command Reference

Parameters
max-power: Sets the maximum power to an integer in the range of 37 to 800, in watts.
pse pse-id: Specifies a PSE by its ID.
Usage guidelines
To prevent power supply interruption, the maximum PSE power must be greater than the total
maximum power of all critical PIs.
The total maximum power of PSEs must be smaller than the maximum PoE power.
This command is only available for the default MDC. For more information about MDCs, see Virtual
Technologies Configuration Guide.
Examples
# Set the maximum power to 150 watts for PSE 7.
<Sysname> system-view
[Sysname] poe pse 7 max-power 150
Related commands
poe priority pse

poe mode

Use poe mode to configure a PoE power transmission mode.
Use undo poe mode to restore the default.
Syntax
poe mode { signal | spare }
undo poe mode
Default
The PoE power transmission mode is signal (power over signal cables).
Views
PI view
PoE profile view
Predefined user roles
network-admin
mdc-admin
Parameters
signal: Specifies the PoE power transmission mode as power over signal cables. The system uses
pairs 1, 2, 3, and 6 in the Category 3 or Category 5 twisted pair cable to supply DC power.
spare: Specifies the PoE power transmission mode as power over spare cables. The system uses
pairs 4, 5, 7, and 8 in the Category 3 or Category 5 twisted pair cable to supply DC power. The switch
does not support this keyword.
Examples
# Set the PoE power transmission mode to power over signal cables in PI view.
<Sysname> system-view
[Sysname] interface gigabitethernet 1/0/1
[Sysname-GigabitEthernet1/0/1] poe mode signal
147