Ntp-Service Multicast-Client - HPE FlexNetwork 7500 Series Network Management And Monitoring Command Reference

Default
The maximum number of dynamic NTP sessions is 100.
Views
System view
Predefined user roles
network-admin
mdc-admin
Parameters
number: Sets the maximum number of dynamic NTP associations allowed to be established, in the
range of 0 to 100.
Usage guidelines
A single device can have a maximum of 128 concurrent associations, including static associations
and dynamic associations. A static association refers to an association that a user has manually
created by using an NTP command. A dynamic association is a temporary association created by the
system during operation.
Examples
# Set the maximum number of dynamic NTP associations allowed to be established to 50.
<Sysname> system-view
[Sysname] ntp-service max-dynamic-sessions 50
Related commands
display ntp-service sessions

ntp-service multicast-client

Use ntp-service multicast-client to configure the device to operate in NTP multicast client mode
and use the current interface to receive NTP multicast packets.
Use undo ntp-service multicast-client to remove the configuration.
Syntax
ntp-service multicast-client [ ip-address ]
undo ntp-service multicast-client [ ip-address ]
Default
The device does not operate in any NTP association mode.
Views
Interface view
Predefined user roles
network-admin
mdc-admin
Parameters
ip-address: Specifies a multicast IP address. The default is 224.0.1.1. A multicast server and client
must be configured with the same multicast IP address.
111