Diagnostic Ondemand Failure; Diagnostic Ondemand Repeating - HPE FlexNetwork 7500 Series Network Management And Monitoring Command Reference

diagnostic ondemand failure

Use diagnostic ondemand failure to set the maximum number of failed on-demand diagnostic
tests.
Use undo diagnostic ondemand failure to restore the default.
Syntax
diagnostic ondemand failure failure-number
undo diagnostic ondemand failure
Default
The maximum number of failed on-demand diagnostic tests is not specified.
Views
User view
Predefined user roles
network-admin
Parameters
failure-number: Specifies the maximum number of failed tests, in the range of 1 to 999.
Usage guidelines
After you use the diagnostic ondemand start command to enable on-demand diagnostics, you can
stop the diagnostic tests by using any of the following commands:
•
Use the diagnostic ondemand stop command to immediately stop the tests.
•
Use the diagnostic ondemand repeating command to configure the number of executions for
the tests. The system stops executing the tests when the threshold is reached.
•
Use the diagnostic ondemand failure command to configure the maximum number of failed
tests. The system stops a test when the number of failures reaches the configured threshold
and the test is not executed as many times as specified.
Use this command to configure the maximum number of failed tests for diagnostic tests to be
enabled. This command does not survive a device reboot.
Examples
# Configure the maximum number of failed tests as 5 for all on-demand diagnostic tests.
<Sysname> diagnostic ondemand failure 5
Related commands

diagnostic ondemand repeating

diagnostic ondemand start
display diagnostic ondemand configuration
diagnostic ondemand repeating
Use diagnostic ondemand repeating to configure the number of executions for on-demand
diagnostic tests.
Use undo diagnostic ondemand repeating to restore the default.
Syntax
diagnostic ondemand repeating repeating-number
394