HPE FlexNetwork 7500 Series Network Management And Monitoring Command Reference page 344

Field
IPv6 packet size distribution
(1103746packets in total):
1-32 64 96 128 160 192 224 256
288
320 352 384 416 448 480 512 544
576
1024 1536 2048 2560 3072 3584 4096
4608 >4608
Protocol Total Flows
Flow/Sec Packets/flow
Active(sec)/ flow Idle(sec)/flow
Type DstIP(Port) SrcIP(Port)
TC FlowLbl If(Direct) Pkts
DstMAC(VLAN) SrcMAC(VLAN)
TopLblType(IP/MASK)
TcpFlag:
Description
this command.
Distribution of IPv6 packets by packet size, and the bracketed
number is the total number of IPv6 packets.
The value is displayed in the proportion of the number of IPv6
packets of the specified sizes to the total number of IPv6
packets. The value is displayed with three decimal places.
Range of IPv6 packet length (excluding data link layer header).
•
For the values in the range of 1 to 576 bytes, the range
increases in the step of 32 bytes. For example, 1-32 shows
the number of packets with the size of 1 to 32 bytes. 64
shows the number of packets with the size of 33 to 64
bytes.
•
For the values greater than 1024 bytes, the range
increases in the step of 512 bytes. For example, 1536
shows the number of packets with the size of 1025 to 1536
bytes.
•
Packets with the size of 577 to 1024 bytes are recorded in
the 1024 entry.
Statistics of packets by protocol type:
•
Protocol type.
•
Total number of flows.
Packets/Sec
•
Number of packets per second.
•
Number of flows per second.
•
Number of packets per flow.
•
Active time (in seconds) of each flow.
•
Inactive time (in seconds) of each flow.
Statistics of the active flows in the current cache:
•
Flow type. Flows are classified into the following types:
•
Destination IPv6 address (destination port).
•
Source IPv6 address (source port).
•
Protocol number.
•
Traffic classification.
•
Pro
Flow label.
•
Interface type and name (direction).
•
Number of packets.
ICMPv6 packets do not contain port number fields, so the type
and code fields are captured. The value for the destination port
represents these two fields:
•
The highest 8 bits represent the type field.
•
The lowest 8 bits represent the code field.
The value for the source port is set to 0 and does not indicate
any statistics.
Layer 2 information for the active flows in the current cache:
•
Destination MAC address.
•
Destination VLAN ID.
•
Source MAC address.
•
Source VLAN ID.
Lbl-Exp-S-List These fields are not supported in current release.
Other information about the active flows in the cache:
335
IP flows.
Layer 2 flows with IPv6 protocol information (IPL2).