HPE FlexNetwork 7500 Series Network Management And Monitoring Command Reference page 138

Views
Any view
Predefined user roles
network-admin
network-operator
mdc-admin
mdc-operator
Parameters
interface-type interface-number: Specifies an interface by its type and number.
Usage guidelines
The interface-type interface-number argument is optional for the default MDC and is required for
non-default MDCs. For the default MDC, if you do not specify an interface, this command displays
power supplying information for all PIs.
Examples
# Display power supplying information for GigabitEthernet 1/0/1.
<Sysname> display poe interface gigabitethernet 1/0/1
PoE Status
Power Priority
Oper
IEEE Class
Detection Status
Power Mode
Current Power
Average Power
Peak Power
Max Power
Electric Current
Voltage
PD Description
Table 22 Command output
Field
PoE status
Power Priority
Oper
: Enabled
: Critical
: On
: 1
: Delivering power
: Signal
: 11592 mW
: 11610 mW
: 11684 mW
: 15400 mW
: 244 mA
: 51.7 V
: IP Phone For Room 101
Description
PoE status:
•
Enabled.
•
Disabled.
Power supply priority of the PI:
•
Critical (highest).
•
High.
•
Low.
Operating status of a PI:
•
Off—PoE is disabled.
•
On—Power is being supplied to the PI correctly.
•
Power-lack—Remaining guaranteed power is insufficient for a
critical PI.
•
Power-deny—The PSE refuses to supply power. The power
required by the PD is higher than the configured power.
129