Mirroring-Group Monitor-Port (Interface View) - HPE FlexNetwork 7500 Series Network Management And Monitoring Command Reference

•
Spanning tree.
•
802.1X.
•
IGMP snooping.
•
Static ARP.
•
MAC address learning.
Do not configure a port of an existing mirroring group as an egress port.
Examples
# Create remote source group 1. Configure GigabitEthernet 1/0/1 as its egress port in system view.
<Sysname> system-view
[Sysname] mirroring-group 1 remote-source
[Sysname] mirroring-group 1 monitor-egress gigabitethernet 1/0/1
# Create remote source group 2. Configure GigabitEthernet 1/0/2 as its egress port in interface view.
<Sysname> system-view
[Sysname] mirroring-group 2 remote-source
[Sysname] interface gigabitethernet 1/0/2
[Sysname-GigabitEthernet1/0/2] mirroring-group 2 monitor-egress
Related commands
mirroring-group

mirroring-group monitor-port (interface view)

Use mirroring-group monitor-port to configure a port as the monitor port for a mirroring group.
Use undo mirroring-group monitor-port to remove the monitor port from a mirroring group.
Syntax
mirroring-group group-id monitor-port
undo mirroring-group group-id monitor-port
Default
No monitor port is configured for a mirroring group.
Views
Interface view
Predefined user roles
network-admin
mdc-admin
Parameters
group-id: Specifies a mirroring group by its number in the range of 1 to 4. The specified mirroring
group must already exist.
Usage guidelines
You can configure monitor ports only for local mirroring groups and remote destination groups.
Do not enable the spanning tree feature on the monitor port of a mirroring group.
For a Layer 2 aggregate interface configured as the monitor port of a mirroring group, do not
configure its member ports as source ports of the mirroring group.
308