Display Poe Device - HPE FlexNetwork 7500 Series Network Management And Monitoring Command Reference

Predefined user roles
network-admin
mdc-admin
Parameters
index index: Specifies a PoE profile by its index number in the range of 1 to 100.
name profile-name: Specifies a PoE profile by its name, a case-sensitive string of 1 to 15 characters.
interface-range: Specifies a range of Ethernet interfaces in the form of interface-type
interface-number [ to interface-type interface-number ], where interface-type interface-number
represents the interface type and interface number. The start interface number must be smaller than
the end interface number. If an interface in the specified range does not support PoE, it is ignored
when the PoE profile is applied.
Examples
# Apply the PoE profile named forIPphone to GigabitEthernet 1/0/1.
<Sysname> system-view
[Sysname] apply poe-profile name forIPphone interface gigabitethernet 1/0/1
# Apply the PoE profile with index number 1 to PIs GigabitEthernet 1/0/2 to GigabitEthernet 1/0/8.
<Sysname> system-view
[Sysname] apply poe-profile index 1 interface gigabitethernet 1/0/2 to gigabitethernet
1/0/8
Related commands
apply poe-profile
display poe-profile interface

display poe device

Use display poe device to display general PSE information, including the ID, slot number, and
status of PSEs.
Syntax
In standalone mode:
display poe device [ slot slot-number ]
In IRF mode:
display poe device [ chassis chassis-number slot slot-number ]
Views
Any view
Predefined user roles
network-admin
network-operator
mdc-admin
mdc-operator
Parameters
slot slot-number: Specifies a card by its slot number. If you do not specify a card, the command
displays information about all PSEs. (In standalone mode.)
127