Group-Member; Loopback-Detection Action - HP 3600 v2 Series Command Reference Manual

Field
Swi-num

group-member

Syntax
group-member interface-list
undo group-member interface-list
View
Port group view
Default level
2: System level
Parameters
interface-list: Specifies an Ethernet interface list, in the form of interface-type interface-number [ to
interface-type interface-number ] &<1- 1 0>, where &<1- 1 0> indicates that you can specify up to 10
interfaces or interface ranges.
Description
Use group-member to assign Layer 2 Ethernet interfaces to a port group.
Use undo group-member to remove Layer 2 Ethernet interfaces from the port group.
By default, a port group does not contain any member ports.
If you use the group-member interface-type interface-start-number to interface-type interface-end-number
command to add multiple ports in batch to the specified port group, make sure that the
interface-end-number argument must be greater than the interface-start-number argument.
Examples
# Assign Layer 2 Ethernet interface Ethernet 1/0/1 to the port group named group1.
<Sysname> system-view
[Sysname] port-group manual group1
[Sysname-port-group-manual-group1] group-member ethernet 1/0/1

loopback-detection action

Syntax
loopback-detection action { no-learning | semi-block | shutdown }
undo loopback-detection action
View
Layer 2 Ethernet interface view, port group view
Default level
2: System level
Description
Number of times the forwarding state of the interface changes.
When the Swi-num count reaches 65,535, it resets automatically.
32