Epson Stylus Pro 7700/7710/7700M/7710M/7900/7910/9700/9710/9900/9910/WT7900/WT7910/9890/9908/7890/7908
5.7.6 Input MAC Address
The MAC address of this printer is recorded on the NVRAM of the Main Board. When
replacing the board, make sure to write the MAC address to the new board as follows.
PROCEDURE
1.
Connect the printer and the computer with the USB cable and the network cable.
2.
Turn the printer ON.
3.
Start the Service Program, and select
ADJUSTMENTS
(INDIVIDUAL).
Figure 5-81. [Input MAC Address] Screen
ADJUSTMENT
Input MAC Address
from
4.
Open the front cover and enter the MAC address written on the MAC address label
attached inside the printer, then click the [Run] button.
MAC address label
After the MAC address is set (after the [Run] button is pressed), it
C A U T I O N
takes some time to restart the network F/W. Before performing the
following procedure, make sure to wait about 90 seconds after the
setting.
5.
Click [Next] to display a confirmation screen. The information written on the
NVRAM is displayed on the screen. Confirm the information and click [OK].
6.
Click [Finish].
Other Adjustment
Figure 5-82. MAC address label
Revision I
424
Confidential