Note:
To remove the pocket unit, place the printer vertically as shown in the illustration below. Then, while
pushing up the lever on the bottom of the pocket unit, push the pocket unit backward. Finally, pull it up to
remove it.
Lever
2.4.3 Connecting the Printer Power Supply
WARNING:
Be sure to use the EPSON PS-180 power supply unit. Using an incorrect power supply unit
may cause fire or electrical shock.
1. Make sure the printer's power switch is turned off.
2. Check the label on the power supply to make sure the voltage required by the power supply
matches your electrical outlet.
3. Plug the DC power cable into the power supply connector.
Note:
To remove the DC power cable, make sure the power supply's power cord is not plugged into the electrical
outlet; then grasp the connector at the arrow and pull it straight out.
4. Turn on the power with the power switch. The POWER LED will come on.
Rev. F
Figure 2-10 Removing the pocket unit
Power supply connector
Figure 2-11 Connector for the power supply
TM-J9000/J9100 Technical Reference Guide
➁
➀
Setup 2-7