Ricoh MP C2504 Field Service Manual page 688

10. During firmware update, a "firmware update/ verification progress screen" is displayed.
When firmware update is complete, a "firmware update end screen" is displayed.
• In the middle row, the name of the module currently being updated is displayed. (in this case,
the printer module is being updated)
• In the lower row, a progress bar is displayed in ten steps. (The more *, the more the
progress.)
<<Firmware update end screen>>
• This screen is displayed when all selected firmware modules are to be updated. "Printer" in the
second row shows that the module updated last is the printer. (When more than one were
updated simultaneously, only the module that was updated last is displayed.)
• When Verify has completed normally, the Update done display of the above screen is "Verify
done." If "Verify Error" is displayed, reinstall the software of the application displayed in the
lower row.
11. After turning the main power OFF, remove the SD card.
12. Turn the main power ON again, and check whether the machine is operating normally.
13. Return the SD card slot cover to the original position.
• When the power supply is switched OFF during firmware update, update is interrupted, and the
power is switched ON again, normal operation cannot be guaranteed.
• To guarantee operation, an update error continues to be displayed until update is successful.
• In this case, insert the SD card again, switch the power ON, and continue download of firmware
from the SD card automatically.
Firmware Update (SD Card)
679