Ricoh MP C2504 Field Service Manual page 508

• The characteristic values attached to the service part must be entered before replacement. It is
recommended that in case Process control/MUSIC after replacement is not completed
successfully, take a note of values of SP3-333, SP3-334 and SP3-335.
1. Note the characteristic values that are listed on the bar code label.
• TM/ID Sensor (front): F, TM/ID Sensor (center): C, TM/ID Sensor (rear): R, be careful.
2. Turn on the main power switch, and then go into the SP mode.
3. Input the characteristic values.
Input data for TM/ID Sensor: F into SP3-333. Input data for TM/ID sensor: C into SP3-334. Input
data for TM/ID sensor: R into SP3-335.
SP No. Classification 1
3-333-001 ID.Sens TestVal:F
3-333-002 ID.Sens TestVal:F
3-333-003 ID.Sens TestVal:F
3-333-004 ID.Sens TestVal:F
3-333-005 ID.Sens TestVal:F
3-333-006 ID.Sens TestVal:F
3-334-001 ID.Sens TestVal:C
3-334-002 ID.Sens TestVal:C
3-334-003 ID.Sens TestVal:C
3-334-004 ID.Sens TestVal:C
3-334-005 ID.Sens TestVal:C
Classification 2
K2: Check
Diffuse Corr
Vct_reg Check:Slope
Vct_reg Check:Xint
Vct_dif Check:Slope
Vct_dif Check:Xint
K2: Check
Diffuse Corr
Vct_reg Check:Slope
Vct_reg Check:Xint
Vct_dif Check:Slope
Image Transfer Unit
Value
TM/ID sensor: F, value of [1]
TM/ID sensor: F, value of [2]
TM/ID sensor: F, value of [3]
TM/ID sensor: F, value of [4]
TM/ID sensor: F, value of [5]
TM/ID sensor: F, value of [6]
TM/ID sensor: C, value of [1]
TM/ID sensor: C, value of [2]
TM/ID sensor: C, value of [3]
TM/ID sensor: C, value of [4]
TM/ID sensor: C, value of [5]
499