Ricoh MP C2504 Field Service Manual page 612

8. Plug in, and then turn on the main power switch.
• When the power is turned ON, SC195-00 appears, but continue with the following steps.
9. Select the destination setting. (SP5-131-001) (JPN: 0, NA: 1, EU/AA/TWN/CHN: 2)
10. Set the following SP, Machine Serial Set (SP5-811-001), Area Selection (SP5-807-001),
and CPM Set (SP5-882-001).
• For information on how to configure this SP, contact the supervisor in your branch office.
11. Turn off the machine, and then turn it back on.
12. Use SP5-801-002 "Memory Clear Engine".
• After changing the EEPROM, Some SPs do not have appropriate initial values. Because of
this, steps 10 to 12 are done.
13. Turn off the machine, and then turn it back on.
14. From the SD card where you saved the NV-RAM data in step 5, download the NV-RAM
data (SP5-825-001).
15. Turn off the machine, and then remove the SD card from slot #2.
16. Turn on the main power switch.
17. Check the factory setting sheet and the SMC data printout from step 2, and set the user
tool and SP settings so they are the same as before.
18. Do ACC (Copier function and Printer function).
SP descriptions
• SP5-811-004 (MachineSerial Set)
Displays/Enters serial number of BCU EEPROM.
• SP5-131-001 (Paper Size Type Selection)
Sets the region setting for paper size/type.
(0: Japan, 1: NA, 2: EU/AA/TWN/CHN)
• SP5-811-001 (MachineSerial)
Displays machine serial number.
• SP5-807-001 (Area Selection)
Sets the machine destination.
(1: Japan, 2: NA, 3: EU, 4: Taiwan, 5: Asia, 6: China, 7: Korea)
• SP5-801-002 (Memory Clear: Engine)
Clears non-volatile memory of engine.
Electrical Components
603