Some Items Must Be Programmed First - Ricoh MV74 Operator's Manual

SOME ITEMS MUST BE PROGRAMMED FIRST

Overview
After you have installed your new machine and connected it to the telephone
line, you should program the following items before you start using the
machine.
Date and Time: See page 198
RTI: See page 204
CSI: See page 206
TTI: See page 205
Language Selection: See page 198
Machine Standby Mode: See page 199
In addition, you also have to make sure that the fax machine's dialing circuits
are set up correctly. There are two settings: Pulse Dial and Tone Dial. If you
select the wrong setting, your machine will not be able to dial fax numbers. If
you are not sure which setting to use, contact your telephone company. To
change this setting, see the following section.
Telephone Line Type: See page 207
If you have a handset attached to your fax machine, make sure that its
dialing circuit is set up correctly.
Additionally, it is recommended you program the following features before
you start to send fax messages.
Summer Time: See page 207
Storing often used numbers: See page 210
Print Quality: See page 200
Magnification Ratios: See page 200
Ink End Detection: See page 202
Test Pattern Printing: See page 203
PABX Access System: See page 208
197