Table of Contents
Advertisement
On this model the
organizations offer you a special service by telephone, which you can access
by transmitting Touch Tone or DTMF tones. If your phone service provides
only pulse dialing, or if you are calling over a digital network, the ability to
generate Tonal Signals will allow you to access these services. First, dial the
other party. When you are through to the other end, press the Tone key and
enter the code number that is needed to access the required feature at the
other terminal. You do not need to press the Tone key if your machine is set
up for dialing in Tone Dial (DTMF) mode.
Using The Tone Key
Make sure that the machine is in standby mode, and that there is no
document in the feeder.
Pick up the telephone handset, or press the On Hook Dial key.
Dial the remote facility. Do not press the Start key.
After your line is connected to the remote facility, do the following:
If your telephone Line type is DTMF (Tone Dial): Go to step 5.
If your telephone line type is Pulse Dial: Press the
pad. A dot appears in the display.
Input the digits that you need to use the remote facility. These digits will
depend on the remote facility. After you have finished your business with
the remote facility, hang up.
NOTE: Do not press the Start key.
key on the ten keypad is used as the Tone key. Some
E
TONAL SIGNALS
on the ten key-
E
77
Advertisement
Table of Contents
