Ricoh MV74 Operator's Manual page 141

CUSTOMIZING THE PRINTER
Epson LQ Mode
When the printer is in Epson LQ mode (Emulation digit 11 is 1), you can set
the Emulation digits to control the following functions:
digit
1 Do not change this setting.
2 Text Scale mode
3 Do not change this setting.
4 Character set
5 to 7 International character set
8 to 10 Typeface
11 Printer control mode
12 Automatic Emulation
13 Smoothing
Emulation digit 2
This setting determines how many lines fit onto a page by adjusting the line
spacing. If you are using a software application that assumes 66 lines will fit
on each page, set this digit to 1. The printer will reduce the line spacing by a
factor of 14/15, which is from 62 lines per page to 66 lines per page if line
spacing is set to 6 lines per inch (lpi).
Emulation digit 4
When this digit is 0, the printer uses the Epson Italics character set, which
includes italic characters. When this digit is 1, the printer uses the Epson
Graphics character set, which includes symbols, lines, corners, and
European characters.
Emulation digits 5, 6, 7
These digits allow you to select one of eight international character sets.
These character sets provide you with the characters and symbols used in
other languages.
130
Purpose 0 (OFF)
Disabled
Italics
See the following descriptions
See the following descriptions
BJ mode
Disabled
Disabled
1 (ON)
Enabled
Graphics
Epson LQ mode
Enabled
Enabled