Table of Contents
Advertisement
MULTI-COPY SETTING
Change the setting of digit 1 by press-
ing 1 using the ten keypad. The result is
shown in the diagram opposite.
Finish: Press the Yes key, then press
the Function key.
Programming the List of Special Senders for Multi-Copy
A terminal sending an incoming message always identifies itself to your
machine. The identification consists of an RTI or CSI. When you specify the
senders for Multi-Copy, you must program a list of these codes. Program the
list by Function 71 (see page 73).
Multi-Copy ON /
OFF (Function 62)
OFF
ON
ON
ON
64
List of Special
Senders
(Function 71)
Empty/Not Empty
Empty
Not Empty
Not Empty
SWITCH 08: 0000 0011
Digit 1
0: Only messages form Special
Senders are multi-copied.
1: All messages are multi-copied
except those from Special
Senders.
Switch 08 Digit 1
(Function 63)
Either
Either
0
1
KPAD/
j k
Result
No messages are
multi-copied.
All messages are
multi-copied.
Only messages
form Special
Senders are multi-
copied.
All messages are
multi-copied except
those from Special
Senders.
Advertisement
Table of Contents
