If You Make A Mistake; Possible Problems - Ricoh MV74 Operator's Manual

If you make a mistake when inputting a name or number, either :
Press the No key to erase the entire name or number and start again.
Press the Clear key to erase the last letter or digit that you entered.
If you enter the wrong function number,
Press the Function key to return to standby mode and start again.
If you dial the wrong number:
Press the No key to erase the number, then enter it again.
If scanning has already begun, press the Stop key.
If you have already programmed the number into the machine by
pressing the Yes key, remove the document from the feeder and start
again.
You want to take out the document:
Open the operation panel and take it out.
CAUTION: Do not pull out the document without opening the scanner or
you will damage the machine.
You want to send more than 15 pages:
While the last page is being fed in, place more pages (up to 15) in the feeder.
You make a mistake while dialing:
If you have already pressed the Start key, press the Stop key immediately.
If you haven't pressed the Start key yet, either:
Press the No key: The entire number is deleted. Enter a new number.
Press the Clear key: Only the last digit is deleted.
If you find a mistake after scanning and the document has been stored
as a memory file (Memory Transmission):
Use Function 21 to clear the memory file. (see page 40) and start again.
The Check Display indicator is blinking:
An error has been detected. Follow the instructions on the display. For more
information about error displays see page 160.

IF YOU MAKE A MISTAKE

POSSIBLE PROBLEMS

19