Table of Contents
Advertisement
Input the telephone number of the for-
warding station using the ten keypad.
The forwarding station is the number that you
wish to direct incoming messages to.
If your machine is behind a PBX, add the ac-
cess code before the number, unless this for-
warding station is an extension connected to
the same PBX as your machine.
If you do not program any Specified Sender's
identification, all incoming messages will be
forwarded.
Press the Yes key.
Inputting Characters : see page 168.
Either:
If you now wish to enter the Speci-
fied Senders: Press the Yes key.
If you wish to forward all incoming
messages to this station : Press the
No key, go to step 8.
Input the Specified Sender's RTI or CSI,
then press the Yes key so the display is
as right. If the display is not as opposite,
press the Yes key again.
Either:
Store this RTI as a wild card: Press the Yes key.
Otherwise: Press the No key.
Either:
Input another specified sender: Go to step 4.
Finish: Press the Function key.
Input another forwarding station. Press the No key and go to step 3.
FORWARDING MESSAGES
FORWARD
KPAD/
4710319266
llllllll
FORWARD
SET RTI/CSI?
RTI/CSI
llllllllllllllll
RTI/CSI
STORE AS WILD CARD?
j k
Y/N
ABC
j k
Y/N
59
Advertisement
Table of Contents
