Table of Contents
Advertisement
NOTE:
You can select whether or not your machine transmits a
forwarding mark to be printed at the other end on the top of
each page of the output. This mark brings to the other party's
attention that this message has been forwarded. See page 61
for more about the Forwarding Mark.
If one of the specified senders changes their RTI/CSI you must
change the stored RTI/CSI, or you will not be able to forward
messages from that sender.
If you have switched Memory Lock on or receive confidential
messages, you can not use Forwarding.
Cross-references
RTI and CSI: see page 204,206.
Switching Forwarding On/Off
Before you use Forwarding, you have to switch it on using Function 62. After
you switch Forwarding on, " FORWARD " is displayed when the machine is
in standby mode.
Press the Function key and
6,2,2,2,2,6,2 using the ten keypad.
Then press the Yes key.
key until " FORWARDING
Press the
k
ON/OFF " is displayed.
Press the Yes key.
Use the
and the
j
feature on or off.
Press the Yes key to store your setting,
then press the Function key.
keys to switch this
k
FORWARDING MESSAGES
TCR: see page 138,143
Y/NEXT
SELECT LINE
Y/NEXT
FORWARDING ON/OFF
FORWARDING
ON
OFF
k
FORWARDING
ON
OFF
k
FORWARD 100% 10:00AM
SET DOC. OR DIAL NO.
k
k
Y/
j k
Y/
j k
57
Advertisement
Table of Contents
