Table of Contents
Advertisement
INSTALLATION
Never install telephone wiring during a lightning storm.
Never install telephone jack in wet locations
Never touch uninsulated telephone wires or terminals unless the
telephone line has been disconnected at the network interface.
Use caution when installing or modifying telephone lines.
Avoid using a telephone (other than a cordless type) during an electrical
storm. There may be a remote risk of electric shock from lightning.
Do not use the telephone to report a gas leak in the vicinity of leak.
Attaching The Telephone Handset
First, attach the handset holder to its
bracket using the two screws, as shown
in the diagram opposite. (Be careful not
to screw them in too tightly.)
NOTE: Use a coin to screw them in.
Fit the cover over the heads of the
screws.
Install the bracket onto the machine
(see the diagram opposite).
Rest the handset in its holder.
To avoid slack wire hanging at the rear
of the machine, slot the handset lead
into the holder as shown.
Plug the handset jack into the lower
socket labelled "TEL" on the side of
the machine
194
Advertisement
Table of Contents
