Ricoh MV74 Operator's Manual page 59

SENDING CONFIDENTIAL MESSAGES
Making a Confidential Transmission
To set up a Confidential Transmission, do the following:
Make sure that the machine is in
standby mode.
The display on the operation panel must be
as shown on the right.
If you select Memory Transmission, the mes-
sage " READY " in the display is replaced by
" MEM. TX ."
Press the Function key and 1,2 using
the ten keypad, then press the Yes key.
Follow both steps in any order.
Carefully place your document in the
feeder.
Dial then press the Yes key.
Either:
Do a Confidential ID Override(see below).
Press the Start key.
Confidential ID Override Option
This procedure will override the Confidential ID stored in the other party's
machine. The override is only effective for this one transmission. When
" Option " or " OPT
Press the
DENTIAL ID? " is shown, then press
the Yes key.
Input the Confidential ID that you wish
to use for this message. Example: 1212
Press the Yes key.
If you haven't dialed yet, dial now and press the Start key. Otherwise, if
you dialed using the previous option just press the Start key.
48
" is displayed:
k
key until " SET CONFI-
k
READY.100%
SET DOC. OR DIAL NO.
CONFID ' L TRANS
SET DOC. OR DIAL NO.
CONFID ' L TRANS
DIAL FAX NUMBER
CONFID ' L TRANS
3104712262
SET OPTION
ID:
llll
SET OPTION
ID:1212
CONFID ' L TRANS
3104712262
10:00AM
OPT
k
OPT
k
Y/STA
Y/N
Y/N
Y/STA