LOCKING INCOMING MESSAGES
Selecting Which Messages To Lock
Press the Function key and
6,2,2,2,2,6,3 using the ten keypad. then
press the Yes key.
At this time, you can print a user parameter
list, press the
Press the Yes key, then press the
until the settings for Switch 09 are dis-
played.
Change the setting of digit 7 by press-
ing 7 on the ten keypad. The effect is
shown in the table opposite.
To finish: Press the Yes key, then press
the Function key.
NOTE:
If you wish, you can prevent unidentified senders from sending you
messages while Memory Lock is on (See page 69).
Programming the List of Special Senders for Memory Lock
A terminal sending an incoming message always identifies itself to your
terminal. The identification consists of an RTI or CSI. When you use Memory
Lock, you must program a list of these codes as Special Senders using
Function 71 (see page 73).
54
key, then press the Start key.
j
SETTING?
PRINT LIST
key
k
SWITCH 09: 0000:0000
SWITCH 09: 1100:0000
Digit 7
0: Only messages from Special Senders
are locked in memory.
1: All messages are locked in memory
except those from Special Senders.
Y/
j
j
KPAD/Y/
j k
KPAD/Y/
j k