Ricoh MV74 Operator's Manual page 107

SETTING UP THE PRINTER
Printing a Self Test
To check that you have properly set up the printer, you can print one of the
printer's self tests. The self tests are described in detail in the next chapter.
For now, print the Font print:
Press the Function key and 3,5 using
the ten keypad, then press the Yes key.
Press the
k
appears, then press the Yes key.
If " FONT " is not displayed on the bot-
tom line of the display, press the
until it appears. Then press the Yes key.
The printer starts to print the Font.
To stop printing the Font print, hold
down the Clear key for three second un-
til you hear a beep. The printer stops
printing, then ejects the current sheet of
paper.
NOTE If there are missing lines in the printed text or if there is no ink
on the paper, check that the ink cartridge is installed correctly.
You may also need to clean the print head.To do this, just press
the Clear key and Memory key at the same time.
Make sure that the printer is off-line and the machine is in
standby mode.
Installing a Printer Driver
Before you can print documents from your software applications, you must
install the appropriate printer driver on your computer. The printer driver
takes the information from your application program and translates it into a
language the printer can understand.
If you are using Microsoft Windows 3.1 applications, install the Windows
printer driver as described in the next section.
If you are using MS-DOS applications, you must install a printer driver
for each MS-DOS software application that you intend to use with the
printer.
96
key until "SELF TEST"
FORM FEED
SELF TEST
FONT
SELF TEST
FONT
key
k
Y/NEXT
k
Y/
j k
Y/
j k