Ricoh MV74 Operator's Manual page 213

SOME ITEMS MUST BE PROGRAMMED FIRST
Press the Yes key to store your setting,
then press the Function key.
Turning The Mark On or Off (Ink End Detection)
Normally the machine prints a small mark at the top and bottom left side of
each page. A sensor inside the machine monitors the intensity of the
blackness; if the mark printed at the bottom is too pale, the machine
determines that a new ink cartridge must be replaced. The dotted mark
printed at the top is important for the machine to recognize the printing start
position. It only appears when the machine prints received messages.
If you do not wish the marks to appear on your print out, you can switch them
off by doing the following.
NOTE: If you switch this feature off, you will have to judge visually whether
the ink is running out or not.
Press the Function key and
6,2,2,2,2,6,3 using the ten keypad, then
press the Yes key.
At this time, you can print a User Parameter
list. Press the
Press the Yes key. Press the
twice or the
Switch 12 are displayed.
Change the settings of digit 5.
If you wish to change the setting, press
5 using the ten keypad.
Press the Yes key, then press the Function key.
202
key and the Start key.
j
key until the settings for
k
SETTING?
PRINT LIST
key
j
SWITCH 12:0000 0000
SWITCH 12:0010 0000
j
KPAD/Y/
KPAD/Y/
Digit 5
0: Turn the dotted mark On
1: Turn the dotted mark Off
Y/
j
j k
j k