3-4) Load the paper into the entrance.
3-5) Replace the front paper feed carefully.
3-6) Put the paper feed lever back in its origi-
nal position.
Install the ink cartridge:
4-1) Open the front and inside cover.
NOTE: If the inkcartridge holder is not centered, close the front
cove then plug the machine in. The holder will move to the
center
4-2) Prepare the ink cartridge.
Push the right side of the head cap to
the left, it will pop off.
Remove the protective seal.
NOTE: Afterremoving the protective seal and head cap,
do not replace them.
4-3) Lift the green lever [A] and install
the new cartridge[B].
Fit tab [C] over slot [D].
Push the cartridge in.
Push down the lever [A].
4-4) Close the front cover.
Attach the following items
Attached the feed extension - fit them to
the lower copy tray and the document tray,
making sure the fit points up as shown.
Then attach the tray to the machine.
Slide the Quick Dial sheet under the front
panel as shown opposite.
[B]
[C]
[A]
[D]
2