Table of Contents
Advertisement
CUSTOMIZING THE PRINTER
Automatic emulation mode is applicable for MS-DOS applications only. When
you are using Windows, the INKJET MFP printer driver for Windows selects
the appropriate control mode regardless of the settings of emulation digits 11
and 12.
Setting emulation digit 12 to 0 reduces the input buffer by 31 KB.
When using Windows, set Emulation switches 10, 11, and 12 to 0 to
maximise the size of your input buffer (64 KB).
NOTE:
If the printer does not seem to be switching between Epson LQ
mode and BJ mode, disable this function and set Emulation digit
11 to match your application's printer driver.
If you are using a printer switching device, you must allow at
least ten seconds for the printer to recognize an emulation
change. If your printer switching device switches data in less
than ten seconds, automatic emulation switching will not
function properly.
Emulation digit 13
Set this digit to 1 to enable the smoothing mode, which is used with the INK
CARTRIDGE TYPE 120 BLACK only. When smoothing is enabled, the
printer refines your printout by polishing away the jagged edges and ragged
stair-stepping curves of characters and graphics. This results in sharp and
crisp printout at 720 (horizontal) by 360 (vertical) dots per inch.
NOTE:
When to use smoothing:.
Enable smoothing when printing from MS-DOS applications with
the INK CARTRIDGE TYPE 120 BLACK using the printer's internal
fonts. Smoothing is especially effective for printing double height,
double width, italic characters, and combinations of these charac-
ters.
132
Advertisement
Table of Contents
