Installing Valves And Fittings In The Unheated Compartment; Installing The Needle Valves And The Sample Inlet Fittings Into The Unheated Compartment - Thermo Scientific TRACE 1300 Instruction Manual

Installing Valves and Fittings in the Unheated Compartment

Installing the Needle Valves and the Sample Inlet Fittings into the Unheated
Compartment
Thermo Scientific
Figure 66. Gas Connection
4. Testing the valve.
a. Configure the valve and rotate it clockwise and counter-clockwise.
b. Ensure that the valve moves freely in both directions.
c. Inspect the valve stop when the valve is in both positions to ensure that the stop is at
the movement limit on each side.
This section provides the instructions to install valves and sample inlet fittings in the unheated
compartment.
Related topics:
• "Installing the Needle Valves and the Sample Inlet Fittings into the Unheated
Compartment" on page 49
• "Installing an Unheated Rotary Valve into the Unheated Compartment"
• "Installing an Unheated Diaphragm Valve into the Unheated Compartment"
• "Installing an Unheated Valve for Liquid Sample into the Unheated Compartment"
page 63
This section provides the instructions to install a needle valve and a sample inlet fitting on the
back or on the front panel of the TRACE 1310 Auxiliary Oven.
Related Topics:
• "To install a needle valve and the sample inlet fitting into the back unheated
compartment" on page 50
3
Installing Valves and Fittings in the Unheated Compartment
TRACE 1310 Auxiliary Oven Instruction Manual
Components Installation
on page 55
on page 59
on
49