Coupling The Trace 1310 Auxiliary Oven To The Gc - Thermo Scientific TRACE 1300 Instruction Manual

3
Components Installation

Coupling the TRACE 1310 Auxiliary Oven to the GC

Coupling the TRACE 1310 Auxiliary Oven to the GC
104 TRACE 1310 Auxiliary Oven Instruction Manual
 To couple the TRACE 1310 Auxiliary Oven to the GC
This section provides the instructions for coupling the TRACE 1310 Auxiliary Oven with the
GC.
1. Prepare the duct for the insertion of the TRACE 1310 Auxiliary Oven inner tube into the
GC oven.
a. Remove the partial cut shaped plate from the exterior right wall of the GC oven box
to access the insulating material. See
Figure 155. Perform the Duct (1)
b. Using a knife or similar tool, gently cut the insulating material following the track.
c. Save the removed insulating material in a safe place because it could be reused.
d. On the right side wall in the interior of the oven, remove the partial cut plate from
the corresponding duct. See
Figure 156. Perform the Duct (2)
Figure 155.
Figure 156.
Partial Cut Plate
Partial Cut Shaped Plate
Thermo Scientific