Powering On The Trace 1310 Auxiliary Oven - Thermo Scientific TRACE 1300 Instruction Manual

5
Maintenance & Troubleshooting

Powering On the TRACE 1310 Auxiliary Oven

Powering On the TRACE 1310 Auxiliary Oven
120 TRACE 1310 Auxiliary Oven Instruction Manual
 To power on the TRACE 1310 Auxiliary Oven
1. )Verify that all the connections have been properly done.
2. Open the supply gases.
3. Plug the power cable to the AC Input connector (Main socket) on the TRACE 1310
Auxiliary Oven, and to the wall outlet. See
Figure 169. TRACE 1310 Auxiliary Oven Power On
4. If auxiliary detectors are installed, be sure the carrier gas flowing through the column and
the detector gases flowing through the detector.
5. Power on the GC.
a. If external modules are present, plug the power cable to the AC Input connector of
each module, and to the wall outlet.
b. Flip up the power switch, located on the back side of the GC, to the On (up) position
marked I.
Figure 169.
AC Input Connector
Thermo Scientific