Back View - Thermo Scientific TRACE 1300 Instruction Manual

Back View

Thermo Scientific
Figure 6 shows the components located on the back of the TRACE 1310 Auxiliary Oven.
Figure 6. TRACE 1310 Auxiliary Oven Back View
The components are:
• Four inlet ports for carrier gas and auxiliary detector gases marked H2 R+L, Make-Up R,
Air L+R, and Make-Up L.
• Up to two fans for the cooling of the auxiliary detectors.
• Six seats marked 9, 10, 11, 12, 13, and 14 for the installation of unheated needle valves.
• Six seats marked A, B, C, D, E and F for the installation of sample inlet/outlet fittings.
• A duct for the connection of a heated sample transfer line.
• An ACTUATING GAS inlet port for the carrier flow connection marked Carrier Gas for
the actuation of the AFP™ diaphragm valves. The inlet pressure is 450 kPa; 65 psi.
• An ACTUATING GAS inlet port for the actuating flow connection marked AIR for the
actuation of the VICI ® rotary valves, VICI ® valves for liquid sample (ASFVO), or both.
The inlet pressure is 450 kPa; 65 psi.
2
TRACE 1310 Auxiliary Oven Overview
Cooling fans for Auxiliary Detectors
Inlet Ports for Carrier and Detector
gases
Housing for the optional Secondary
Oven or Methanizer
Seats for Needle Valves
Duct for Heated Sample
Transfer Line
Seat for Sample Inlet/Output Fitting
Gas Inlet Port for Diaphragm Valves
Air Inlet Port for Rotary Valves
Cooling Fan
Auxiliary Gas System Gas Inlet Ports
Marked 4,5,6
AC Input Connector
Auxiliary Gas System Gas Inlet Ports
Marked 1,2,3
TRACE 1310 Auxiliary Oven Instruction Manual
Back View
,
13