Installing Solvent Shut Off Valves - Thermo Scientific thermoscientific Vanquish Pumps C Operating Manual

5.6.6

Installing Solvent Shut Off Valves

When
Parts and additional items required
Preparations
Follow these steps
Pumps C, Pumps F ( VC-Pxx, VF-Pxx)
Operating Manual
9. Check the solvent lines across the entire flow path. Make sure that
the lines are not bent, pinched, or squeezed at any point in the flow
path.
10. If applicable, reinstall the seal wash detector assembly.
These steps apply only when installing a shut off valve during initial
setup of the pump. To install a shut off valve after initial operation of the
pump, follow the steps in
To shut off the solvent flow through the system at the solvent reservoir,
for example, to prevent solvent from flowing through the system when
you open a flow connection on the low-pressure side
• Shut off valve, kit containing one shut off valve and fitting
connections
• Tubing cutter
Prepare the pump and follow the steps in
(} page 64).
Figure 20: Installing a shut off valve in the solvent line
No. Description
1 Solvent line
2 Fitting
3 Ferrule
4 Shut off valve
Installing Solvent Shut Off Valves
Connecting the Solvent Lines
5 • Installation
(} page 110).
Page 69