Tools Needed - Thermo Scientific TRACE 1300 Instruction Manual

Tools Needed

Thermo Scientific
Figure 38. Auxiliary Detector Housing
The tools needed for installing the components into the TRACE 1310 Auxiliary Oven are
listed in Table 6.
Table 6. Tools Required (Sheet 1 of 2)
Tool
T30 Torxhead screwdriver
T25 Torxhead screwdriver
T20 Torxhead screwdriver
T20 Torxhead L-shape wrench
T10 Torxhead L-shape wrench
T8 Torxhead L-shape wrench
1/4- 5/16-in. open-end wrench
5/8-in. open-end wrench
7/16-in. open-end wrench
1/2-in. open-end wrench
7-mm combo open-end wrench
8-mm combo open-end wrench
3/8-in. Allen wrench
2
Detector Gases Connection Label
Interested Components
Main oven cover fixing screws
M5 screws of the Auxiliary Gas module (for example:
the screw that plug the split inlet).
All the accessible M4 screws
All the inaccessible M4 screws (for example: to fix the
solenoid valve manifold on the roof.
Auxiliary Gas board
Mixer (Tee fitting) installation on the Methanizer
assemble
Valve head nuts
Valco® needle valves
Fittings crossing and 1/8-in. nuts
Fitting nut on the rear panel
Unheated valves and valves for liquid samples
(ASFVO) on the plate
Unheated membrane valves on the plate, and
M5/10-32 fittings
Actuator of the rotary valve
TRACE 1310 Auxiliary Oven Instruction Manual
TRACE 1310 Auxiliary Oven Overview
Tools Needed
31