3
Components Installation
Installing Valves and Fittings in the Unheated Compartment
54
TRACE 1310 Auxiliary Oven Instruction Manual
b. Mount the extension on the desired seat of the plate by matching its fixing holes to
the fixing holes on the plate.
c. Insert the three fixing screws into the corresponding fixing holes, then tighten the
screws using the proper Torxhead key or screwdriver. See
Figure 76. Needle Valve and Sample Inlet Fitting Installation (6(
d. Carefully insert and screw the sample inlet fitting into the extension. See
Figure 77. Needle Valve and Sample Inlet Fitting Installation (7)
Figure
76.
Figure
47.
Thermo Scientific