3Com VCX V7000 Installation Manual page 461

e Press the start button on the front panel.
2 Configure the networking and services parameters on the down server
using this command:
vcx-setup
For detailed instructions, see
Chapter 6.
3 If necessary, upgrade the software version on the down server to match
the software version of the other servers in the VCX system.
a Compare the software version on the down server to the software
version on another server in the VCX system.
On the running server and on the other server, enter this command:
vcx-showversion
b If the down server is running an earlier software version than the
running server, download the appropriate software upgrade file to the
/opt/installtemp
The location of the software upgrade file depends on 3Com's service
delivery methods and on the customer network configuration.
Software upgrade file names begin with the software version and end in
a extension (for example: vcx-ipmsg-6.0.2c.tar). The examples in this
.tar
section assume that you need to upgrade to VCX 6.0.2c.
4 After the setup has been completed, update the Call Records Server with
the IP addresses of the Accounting Servers from which it must collect call
records. See "Adding Accounting Servers to the Call Records Server" in
the VCX Administration Guide.
This marks the end of the outage.
Replacing a Disk (Regional Office)
"Configuring a Call Records Server"
directory on the down server.
459
in