3Com VCX V7000 Installation Manual page 101

vcx-setup
Sample Network Configuration Script — Branch Office Server
---------------------------------------------------------------------------
------------- Welcome to the VCX Network Configuration Wizard -------------
---------------------------------------------------------------------------
This wizard sets up networking and related services.
Configure networking now? [yes] :
--------- Configuring Dynamic Host Configuration Protocol (DHCP) ----------
VCX servers can use DHCP for automated configuration, but this requires
that the DHCP server is configured to provide the proper options.
you know that your environment is set up in this way, you should say 'no'
here and configure static network parameters.
Use DHCP on eth0 to configure network parameters? [yes] : no
-------------------------- Configuring Hostname ---------------------------
Enter system hostname
When you install the branch office server, use this site name. Site names
can be up to 22 characters long and can contain only the characters A-Z,
a-z, and 0-9. No punctuation characters, spaces, or tabs may be used.
5 When the script prompts you with this question, enter y.
Do you want to continue with the above settings ? [n/y]:
CAUTION: Before you begin the installation process on the branch office
server, first verify that the regional office Authentication and Directory
server is running properly and accessible via the network.
To begin the installation of the branch office server, log in as root and
enter this command:
The configuration script starts. The first portion deals with network
configuration.
Press the Enter or Return key to accept the suggested answer (yes).
IP addresses for VCX servers must be static addresses. Enter no to
configure the network parameters for eth0 manually.
:
Enter the unqualified name that you want to use for this primary server
(for example, vcx01). Unqualified host names must conform to the rules
outlined in "Host Names" in Chapter 1.
101
Unless