3Com VCX V7000 Installation Manual page 348

346 A B: A
PPENDIX UTOMATED
Do you wish to change any of the Auth & Dir Service parameters? [N] :
------------ Configuring additional parameters for Common Agent ------------
The Trap Destination specifies the IP address to be used as a destination
when this system sends SNMP traps.
Trap Destination
The Trap Community String provides a community string to be used when
sending SNMP traps to the trap destination.
Trap Community String
In some cases it may be desirable for SNMP Traps to be sent to multiple
destinations. Additional Trap Destinations can be entered here.
blank input to indicate that all destinations have been entered.
IP Address of the first additional trap destination for this system.
Trap Destination
B O I
RANCH FFICE NSTALLATION
Sample vcx-createcfg Script (continued)
Press the Enter or Return key to accept the default answer (N), or enter Y
to change one or more of the values.
Enter the IP address of the PC or other system on which you are running
your network management software (for example, EMS).
CAUTION: This parameter can be configured only in the .ini file. If you
attempt to configure it through the browser interface, all calls on the
Media Gateway are interrupted and the SNMP trap destination is not set.
CAUTION: Press the Enter or Return key to accept the default answer
(public). 3Com strongly recommends that users change this string for
security reasons.
If desired, enter the IP address of an additional PC or other system on
which you are running your network management software (for example,
EMS).
:
: public
Enter a
: