3Com VCX V7000 Installation Manual page 287

4 Plug the other end of the power cord into the power connector on the
telephone.
5 Before the telephone finishes the download of code from the VCX Call
Processing Server, press the Select button, located in the center of the
four arrow buttons.
6 Press 5 (Set NCP IP).
7 Enter the IP address of the Primary VCX Call Processing Server.
8 Press # to save the Primary Call Processing Server IP address.
VCX systems typically have two Call Processing servers. One is the primary
server and the other is the alternate server, which is available for fail-over
purposes.
9 Press the Select button.
10 Press 6 (VCX Cnfig Menu).
11 Press 1 (Alt Dnld Dervr).
12 Enter the IP address of the Alternate Call Processing Server.
13 Press # to save the Alternate Call Processing Server IP address.
14 Disconnect and reconnect the telephone power cord.
The telephone:
Obtains an IP address from a DHCP in your network.
■
Contacts the Primary Call Processing Server and begins to download
■
the appropriate software.
During the downloading process, several progress messages appear in
the telephone display panel. After the software has been downloaded to
the telephone, the message "Local Phone Number:" appears.
To log in on the telephone, a user enters:
An extension number, followed by #
■
A numeric password, followed by #
■
To assign a telephone extension to a user, you must configure the
telephone extension number and user ID using the VCX Administrator
User Interface. For information about how to perform these tasks, see the
VCX Administration Guide.
Telephone Installation 287