3Com VCX V7000 Installation Manual page 362

360 A B: A
PPENDIX UTOMATED
Sample V6000 Media Gateway Configuration File (continued)
USERNAME = 'VCX-V6000'
DEFAULTRELEASECAUSE = 34
PROGRESSINDICATOR2IP = 0
ISFALLBACKUSED = 1
ISPROXYHOTSWAP = 1
B O I
RANCH FFICE NSTALLATION
Enter VCX-V6000 as the user name to be used for registration and
authentication. NOTE: This parameter is used only if the Authentication
Mode is "Authentication Per Gateway."
When an outgoing call over an FXO line is released by the gateway, a
cause is associated with the release. Specify a cause that will be used if no
other release cause can be found. Possible values are:
3 — NO_ROUTE_TO_DESTINATION
■
34 — NO_CIRCUIT_AVAILABLE
■
27 — DESTINATION_OUT_OF_ORDER
■
Select the type of progress indicator that you want the gateway to send.
Possible values are:
0 — The gateway sends "180 Ringing" for calls placed to FXS
■
endpoints or to a PBX over an FXO line.
1 — The gateway sends "183 Session in Progress" if the
■
EnableEarlyMedia parameter is enabled (set to 1).
8 — Same as 1.
■
-1 — Not configured. Default values are used.
■
Depending on the value of EnableEarlyMedia, the gateway should send
one of these progress indicators.
Enable (1) or disable (0) the ability of the gateway to use the internal "Tel
to IP" routing table whenever it cannot contact a Proxy. When the
gateway finds a Proxy, it switches from using the internal routing table to
using proxy routing again.
Enable (1) or disable (0) the ability of the gateway to send SIP INVITE
messages to a secondary SIP Proxy if the primary proxy does not respond
after the configured number of retries.